Research Article | | Peer-Reviewed

Effects of Optimized Physical Vibration Parameters on Enhanced Oil Recovery

Received: 28 November 2023     Accepted: 19 December 2023     Published: 28 December 2023
Views:       Downloads:
Abstract

In this paper the optimized vibro-seismic parameters for enhancing the productivity of the oil wells through water flooding is studied and presented. The main idea of the vibro-seismic application in the petroleum industry is to provide energy to the reservoir rock through the use of either physical vibration or acoustic waves vibrations to enhance the rock and rock-fluid properties which in turn may result in improving the oil recovery. The optimized parameters that are investigated here included frequency, amplitude (energy) and the vibration duration (time). It was found that the optimization of these three parameters is essential to make sure that the vibro-seismic treatment will enhance the rock properties or otherwise it may result in damaging the reservoir. Multiple core plugs with different porosities and permeabilities are used to investigate the effect of the vibro-seismic on the enhanced oil recovery for different reservoirs. Also, multiple combinations of parameters; frequency, amplitude and time are used and the optimum combinations for the different reservoir properties are obtained. The steps that are taken in this paper for the optimization is to compare the effect in the water flooding results with different vibration parameters to that obtained without vibrations to select the optimum vibration combination. The experimental work showed that there was an increase in recovery for all of the cores with different percentages when compared to the initial case of just waterflooding if the vibration parameters are optimized. Full discussion of the results and recommendations for further investigations are discussed.

Published in Petroleum Science and Engineering (Volume 7, Issue 2)
DOI 10.11648/j.pse.20230702.13
Page(s) 43-49
Creative Commons

This is an Open Access article, distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution and reproduction in any medium or format, provided the original work is properly cited.

Copyright

Copyright © The Author(s), 2023. Published by Science Publishing Group

Keywords

Vibroseismic, Waterflooding, EOR, Phyiscal Vibration

References
[1] Abdulfatah, H. K. "Application of Ultrasonic Waves in Enhancing Oil Recovery in Secondary Recovery Phase." Paper presented at the SPE Annual Technical Conference and Exhibition, Dallas, Texas, USA, September 2018. doi: https://doi.org/10.2118/194031-STU
[2] Alhomadhi, E., Amro, M., and Almobarky, M. 2013. Experimental application of ultrasound waves to improved oil recovery during waterflooding. Journal of King Saud University, 2014, (26):, 103-110. dx.doi.org/10.1016/j.jksues.2013.04.002.
[3] Ariadji, T. "Effect of Vibration on Rock and Fluid Properties: On Seeking the Vibroseismic Technology Mechanisms." Paper presented at the SPE Asia Pacific Oil and Gas Conference and Exhibition, Jakarta, Indonesia, April 2005. doi: https://doi.org/10.2118/93112-MS
[4] Beresnev, I., Johnson, P. 1992. Elastic-wave stimulation of oil production: A review of methods and results. GEOPHYSICS, 59, (6):, 1000-1017.
[5] Boeut, S., Oshima, T., Fujii, Y., et. al. 2019. Variation in the Permeability of Intact and Fractured Rocks due to Transient Disturbances in Axial Stress or Pore Pressure. Advances in Civil Engineering, 2019, ():, 1-16. doi.org/10.1155/2019/1312746.
[6] Bizzarri, A. 2012. Effects of Permeability and Porosity Evolution on Simulated Earthquakes. Journal of Structural Geology 38: 243-253. http://dx.doi.org/10.1016/j.jsg.2011.07.009.
[7] Kitamura, K., Takahashi, M., Mizoguchi, K. et al. 2010. Effects of pressure on pore characteristics and permeability of porous rocks as estimated from seismic wave velocities in cores from TCDP Hole-A. Geophysical Journal International 182 (3): 1148-1160. http://dx.doi.org/10.1111/j.1365-246x.2010.04694.x.
[8] Lockner, D. and Beeler, N. 2002. Rock Failure and Earthquakes. NTERNATIONAL HANDBOOK OF EARTHQUAKE AND ENGINEERING SEISMOLOGY, 81A. J. Byerlee, C. Sammis, C. Scholz, R. Sibson, and W. Stuart, Chap. 32. 505-537. USA: Int'l Assoc. Seismol. & Phys. Earth's Interior, Committee on Education.
[9] Manga, M., Beresnev, I., Brodsky, E. et al. 2012. Changes in permeability caused by transient stresses: Field observations, experiments, and mechanisms. Reviews of Geophysics 50 (2): http://dx.doi.org/10.1029/2011rg000382.
[10] Mohammadian, E., Shirazi, M. A, Kamal, A. I. "Enhancing Oil Recovery through Application of Ultrasonic Assisted Waterflooding." Paper presented at the SPE Asia Pacific Oil and Gas Conference and Exhibition, Jakarta, Indonesia, September 2011. doi: https://doi.org/10.2118/145014-MS
[11] Nikolaevskiy, V. N., Lopukhov, G. P., Yizhu, Liao, and M. J. Economides. "Residual Oil Reservoir Recovery with Seismic Vibrations." SPE Prod & Fac 11 (1996): 89–94. doi: https://doi.org/10.2118/29155-PA
[12] Oraby, M., Abdalla, M., Aal, T. et al. 2022. Optimization of the vibration parameters in the vibro-seismic applications. Journal of Petroleum Science and Engineering 219: 111029. http://dx.doi.org/10.1016/j.petrol.2022.111029.
[13] Roberts, P., Majer, E., Lo, W., Sposito, G., & Daley, T. (2002). An integrated approach to seismic stimulation of oil reservoirs: laboratory, field and theoretical results from doe/industry collaborations. Lawrence Berkeley National Laboratory.
[14] Salem, A. and Snosy, M. 2015. The Effect of Ultrasonic Waves of EOR on the Relative Permeability Curves. Presented at SPE Kuwait Oil & Gas Show and Conference, Mishref, Kuwait, 11–14 October, 175410-MS.
[15] Sitompul, V., Alfian, M., Sitompul, F. O., Winata, D., et al. "Breakthrough Enhanced Oil Recovery Technology with Low Cost & Fast Yield on Pilot Test of Vibroseismic EOR Technology in Tempino Field, Sumatera, Indonesia." Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, Virtual, October 2021. doi: https://doi.org/10.2118/205746-MS
[16] Zhang, L. H., Ho, P., Yun, L., et al. "Low Frequency Vibration Recovery Enhancement Process Simulation." Paper presented at the SPE Reservoir Simulation Symposium, Houston, Texas, February 1999. doi: https://doi.org/10.2118/51914-MS
Cite This Article
  • APA Style

    Ahmed Abdel Aal, T., Oraby, M., Moussa, M. (2023). Effects of Optimized Physical Vibration Parameters on Enhanced Oil Recovery. Petroleum Science and Engineering, 7(2), 43-49. https://doi.org/10.11648/j.pse.20230702.13

    Copy | Download

    ACS Style

    Ahmed Abdel Aal, T.; Oraby, M.; Moussa, M. Effects of Optimized Physical Vibration Parameters on Enhanced Oil Recovery. Pet. Sci. Eng. 2023, 7(2), 43-49. doi: 10.11648/j.pse.20230702.13

    Copy | Download

    AMA Style

    Ahmed Abdel Aal T, Oraby M, Moussa M. Effects of Optimized Physical Vibration Parameters on Enhanced Oil Recovery. Pet Sci Eng. 2023;7(2):43-49. doi: 10.11648/j.pse.20230702.13

    Copy | Download

  • @article{10.11648/j.pse.20230702.13,
      author = {Tarek Ahmed Abdel Aal and Mostafa Oraby and Marwan Moussa},
      title = {Effects of Optimized Physical Vibration Parameters on Enhanced Oil Recovery},
      journal = {Petroleum Science and Engineering},
      volume = {7},
      number = {2},
      pages = {43-49},
      doi = {10.11648/j.pse.20230702.13},
      url = {https://doi.org/10.11648/j.pse.20230702.13},
      eprint = {https://article.sciencepublishinggroup.com/pdf/10.11648.j.pse.20230702.13},
      abstract = {In this paper the optimized vibro-seismic parameters for enhancing the productivity of the oil wells through water flooding is studied and presented. The main idea of the vibro-seismic application in the petroleum industry is to provide energy to the reservoir rock through the use of either physical vibration or acoustic waves vibrations to enhance the rock and rock-fluid properties which in turn may result in improving the oil recovery. The optimized parameters that are investigated here included frequency, amplitude (energy) and the vibration duration (time). It was found that the optimization of these three parameters is essential to make sure that the vibro-seismic treatment will enhance the rock properties or otherwise it may result in damaging the reservoir. Multiple core plugs with different porosities and permeabilities are used to investigate the effect of the vibro-seismic on the enhanced oil recovery for different reservoirs. Also, multiple combinations of parameters; frequency, amplitude and time are used and the optimum combinations for the different reservoir properties are obtained. The steps that are taken in this paper for the optimization is to compare the effect in the water flooding results with different vibration parameters to that obtained without vibrations to select the optimum vibration combination. The experimental work showed that there was an increase in recovery for all of the cores with different percentages when compared to the initial case of just waterflooding if the vibration parameters are optimized. Full discussion of the results and recommendations for further investigations are discussed.
    },
     year = {2023}
    }
    

    Copy | Download

  • TY  - JOUR
    T1  - Effects of Optimized Physical Vibration Parameters on Enhanced Oil Recovery
    AU  - Tarek Ahmed Abdel Aal
    AU  - Mostafa Oraby
    AU  - Marwan Moussa
    Y1  - 2023/12/28
    PY  - 2023
    N1  - https://doi.org/10.11648/j.pse.20230702.13
    DO  - 10.11648/j.pse.20230702.13
    T2  - Petroleum Science and Engineering
    JF  - Petroleum Science and Engineering
    JO  - Petroleum Science and Engineering
    SP  - 43
    EP  - 49
    PB  - Science Publishing Group
    SN  - 2640-4516
    UR  - https://doi.org/10.11648/j.pse.20230702.13
    AB  - In this paper the optimized vibro-seismic parameters for enhancing the productivity of the oil wells through water flooding is studied and presented. The main idea of the vibro-seismic application in the petroleum industry is to provide energy to the reservoir rock through the use of either physical vibration or acoustic waves vibrations to enhance the rock and rock-fluid properties which in turn may result in improving the oil recovery. The optimized parameters that are investigated here included frequency, amplitude (energy) and the vibration duration (time). It was found that the optimization of these three parameters is essential to make sure that the vibro-seismic treatment will enhance the rock properties or otherwise it may result in damaging the reservoir. Multiple core plugs with different porosities and permeabilities are used to investigate the effect of the vibro-seismic on the enhanced oil recovery for different reservoirs. Also, multiple combinations of parameters; frequency, amplitude and time are used and the optimum combinations for the different reservoir properties are obtained. The steps that are taken in this paper for the optimization is to compare the effect in the water flooding results with different vibration parameters to that obtained without vibrations to select the optimum vibration combination. The experimental work showed that there was an increase in recovery for all of the cores with different percentages when compared to the initial case of just waterflooding if the vibration parameters are optimized. Full discussion of the results and recommendations for further investigations are discussed.
    
    VL  - 7
    IS  - 2
    ER  - 

    Copy | Download

Author Information
  • Department of Petroleum Engineering, American University in Cairo, Cairo, Egypt

  • Department of Petroleum Engineering, American University in Cairo, Cairo, Egypt

  • Department of Petroleum Engineering, American University in Cairo, Cairo, Egypt

  • Sections